GMTI-2012 control panel

GM2000 SERIES GENSET CONTROLLER Version1.0

INSTALLATION INSTRUCTIONS

The contents are intended for quick guidance and supplement supplement to the user who is using GM2000Ccontroller.

Please read the standard manual for more details.

GM2000C controller has four variants as shown

Note1:GM2011C/GM2012Cwith RS485 interface,GM2011/GM2012 without RS485 interface.

Note2: GM2011C/GM2012C is taken as an example to describe in this manual.

1 KEY FUNCTION DESCRIPTION

	Stop/ Reset	Can stop generator under mode of Manual/Auto; Can reset shutdown alarm;press this key at least 3 seconds to test panel indicators are OK or not (lamp test); During stopping process, press this again can stop generator immediately.
	Start	Start genset under Manual or Auto mode.
	Manual	Pressing this key will setthe the module as Module mode.
	Auto	Pressing this key will setthe the module as Auto mode.
	Running with load	controller is under manual testing mode. Under this mode, genset will run with load automatic when gens are normal. (GM2011Cwithout).
	Set/ Confirm	Enters into Set menu after pressing this, and can shift ursor to confirm.
	Page up/increase	Screen scroll;Shift cursor and increase values.
	Page Down/Decrease	Screen scroll;Shift cursor and decrease values.